FLUID MANAGEMENT EQUIPMENT
MUD VACUUM SYSTEM
-An electric 60 amp 35 barrel round sealed container with 2 suction valves and 4- discharge valves
-Designed for the clean up and suction of water and obm fluids in and around the rig
-Suction 2-3 inch valves Discharge 2-3 inch valves and 2-2 inch valves
-Come’s with 2 inch and 3 inch suction/discharge hoses for reaching rig floor and various options on location
ELECTRIC/DIESEL PRE-MIX MUD TANKS
-ASTM A 36 ¼ inch half-round walls
-Oilfield skid-mounted with 4″ pipe nose bar
-Fully enclosed top deck with foldable handrails
-Primary & backup pump package: Two MCM 250 series 8 x 6 x 14 pumps with hard iron fluid end which includes 11-inch impeller
-Pump suction from tank: 5 inches piped from low point at the rear of the tank down the passenger side to 8 x 6 x 14 centrifugal pump located on pump/mixer platform
-Pump suction from other source: 4 inch suction lines, passenger and driver’s sides, both with butterfly valves and steel plug
-4 & 5 inch passenger side discharge points located mid-operator’s platform, both with butterfly valves and threaded plugs
-4 inch front fill line with 4 inch butterfly valve
-Rear overflow canal at 350-bbl volume with intermediate floor supports
-4″ low point rear drain with butterfly valve and plug
-Internal ladder with depth gauge at 50-bbl increments, readable from the mezzanine
MUD BUCKET
-Air operated mud bucket
-All aluminum construction
-Push button operation
-Immediate re-open ability with push of a button
-Safely unlatches with loss of air pressure
-10″ Mud Bucket
-Height-72 inch
-Foot print- 18 inch x 21 inch
-Weight- 315 lbs
-Discharge- Dual 4
BOP CONTAINMENT
-Aluminum tray 6-8 inches deep with 4-4 inch connections for transport of fluid to desired locations